![]() However in severe cases affected areas must be sanded down and re-finished. These products often contain silicone and silicone oils and only tiny amounts can cause devastating effects.Īfter the first, (affected coat) has been applied, applying further light coats slowly building up to the required finish sometimes can solve the issue. Usually found on metal doors or metal garage. You can use an aggressive water sand paper, I would normally use 600 grit but 1000 will work fine as well. You can water sand and recoat, be sure you feather out the fish eyes well or they will show once you recoat. Any cleaning materials, car valeting materials, car maintenance materials should be sited as far away as possible from the painting area. Fisheyes, small circular, crater-like openings that appear during or shortly after applying a coat of paint. Fish eyes are tough to deal with, especially when using single stage paints such as acrylic enamel.Do not use hammer finish in the same areas as other paint finishes.This also helps to remove trapped moisture. Drain and clean the air pressure regulator daily to make sure that the intake is drawing on clean air.Always thoroughly degrease the surface before and after sanding and make every effort to remove all traces of silicone by thoroughly cleaning with the relevant HMG Preparatory cleaner.Hammer finish or other similar type coatings used in the same area.Air supply contaminated with oil, silicone, dirt, water etc.Even in very small quantities silicone contamination from waxes and polishes, sanding dust, contaminated rags, household cleaning sprays and even cars being polished nearby can cause this effect. Smoothie(R) has become synonymous with fisheye eliminators worldwide Introduced 45 years ago, this full-strength automotive paint additive prevents fisheyes. The high-visibility paint job means youll never lose the robot The 1,600 Dyson 360 Vis Nav promises to be the world’s most powerful robovac Dysons new robovac has a unique design, both. Silicone contamination can be especially difficult to remove and requires extra vigilant cleaning and removal. Often the applicators surface preparation and cleaning is inadequate leaving traces of oils, silicones, water, dirt etc. ![]() Surface contamination is the most common cause.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |